FILTER
This is similar to a current model 2015 PTO tub grinder by Jones/Mighty Giant. Hay grinder or regrind wood grinder. Has over the road tires. Long conveyor. Used about five years ago but we needed something more capable. You could add an engine or make sure you have a couple of hundred hp tractor or … Continue reading “2004 Mighty Giant 2012W”
Good grinder. We ran it daily during our season. NO cab or loader. All the power goes to the mill. The XL has the bigger mill. Great grinder for fast regrind. Holds it’s own in some bigger wood too. No computers. Clutch has been removed and needs replaced. Needs a clutch pack. Newer hammers, radiator, … Continue reading “1992 Morbark 1200XL NCL”
Lower price. Cab and loader. Heat and air work. Good runner. Log loader grapple. Approximately 9k frame hours. Some major engine work around 3800 hours ago (paper work available). Newer radiator, clutch. Augers, mill wear plates, tub floor all excellent or solid. Magnetic head pulley. Good mill bearings. No leaks drips. Newer tires last year. … Continue reading “1994 Morbark 1200L”
Rare, nice track tub grinder. Works flawlessly. Fluid coupler. Remote control. Auxiliary hydraulics with rod puller. Really just too big for us. Shows well. Assorted screens and extra tips.
Ready for work. Owned for last 17 years. (5900 hours at that time) This has the big mill so it’s similar to a 1200XL. Two years ago: New clutch/drive line, torque limiter, pump/injectors and conveyor belt. Magnet. Plumbed for coloring mulch. (Color Pump available) 6 screens. New augers available but not installed. Tub governor doesn’t … Continue reading “1994 Morbark 1200”
1996 or 1997 model year. Good runner. Mill is decent. Engine runs great. Plenty of power. Cab and seat needs a little updating if you want to use it. Grapple was removed but could be reattached. It could use a couple of minor wiring upgrades. Augers are have some wear but still discharges our regrind … Continue reading “1996 Morbark 1300”
Possible owner financing! Low hour machine (Hours are since major overhaul of engine). Unit has been well maintained. Preventative maintenance done consistently. Hardfacing constantly done an all high wear surfaces. Newer paint on the machine as well. Cab and loader. Magnetic head. Manual reversing fan. The following items have been replaced/upgraded within the past 5 years: Gear … Continue reading “2002 Morbark 1300”
Good horsepower in this Progrind 4000 without a loader. In good working condition. Entire electric control panel rebuilt ($18,000). Magnet. Batteries are new 2020. The hydraulic motor and the gear box for the tub is new from 2019 (less than 60 hours work). Fixed hammers. 5 screens sized from 2½’’ to 3’’ either round or square holes. … Continue reading “1997 Toro Progrind 4000”
1990. Good condition with fairly new hammers. Newer clutch. Conveyor does not fold up. Same owner for about 10 years. 2”, 1.5” screens.
Recent cylinder head, turbo, water pump, radiator, radiator fan, starter and conveyor. I added remote control to start and stop the tub. Have multiple screens for it. Four 2″ screens and one 3″ screen. All are round hole screens. The hammers are better than 50% on one side and 100% on the other. It has 1/2″ … Continue reading “1990 Haybuster IG7”
